BS ISO 8788:2020 Aerospace – Nuts, metric – Tolerances of form and position

BS ISO 8788:2020 Aerospace – Nuts, metric – Tolerances of form and position.
1 Scope
This document defines the tolerances of form and position of metric nuts meant for aerospace
construction . These tolerances comply with ISO 1101 , 1S0 2692 and IS0 5459
2 Normative references
There are no normative references in this document
3 Terms and definitions
No terms and definitions are listed in this document
ISO and IEC maintain terminological databases for use in standardization at the following addresses
IsoOnlinebrowsingplatformavailableathttps://www,iso,org/obp
leCElectropedia:availableathttp://www,electropedia.o
4 Types of nuts , illustration of tolerances of form and position , values
See Table 1 for the tolerances of form and position to be applied in relation to the type of nut , Table 2 to
Table 11 for the illustration of tolerances of form and position for different types of nut . See Tables 12
and Table 13 for the values of the tolerances In the ” illustration ” column , only one type of nut has been
shown as an example , but the corresponding tolerance applies to all types of nut specified in the third
column.
BS ISO 8788  pdf download.