BS ISO 10968-2020 Earth-moving machinery一Operator’s controls.
This document specifies requirements and guidelines for the operator’s controls on earth-moving machinery as defined in ISO 6165, in as far as those controls relate to any direct-control machine. The recommendations given for finger-, hand- and foot-operated controls are not intended to prevent usage of other types of controls, control locations or control movements. This document is not applicable to devices which are not directly related to machine control.
NOTE For remote operator control of machines, see ISO 15817.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 3411, Earth-moving machinery — Physical dimensions of operators and minimum operator space envelope
ISO 3450, Earth-moving machinery — Wheeled or high-speed rubber-tracked machines — Performance requirements and test procedures for brake systems
ISO 5010, Earth-moving machinery — Wheeled machines — Steering requirements
ISO 6405-1, Earth-moving machinery — Symbols for operator controls and other displays — Part 1:
Common symbols
ISO 6405-2, Earth-moving machinery — Symbols for operator controls and other displays — Part 2:
Symbols for specific machines, equipment and accessories
ISO 10265, Earth-moving machinery — Crawler machines — Performance requirements and test procedures for braking systems
ISO 17063, Earth-moving machinery — Braking systems of pedestrian-controlled machines — Performance requirements and test procedures
3 Terms and definitions
For the purposes of this document, the following terms and definitions apply.
ISO and IEC maintain terminological databases for use in standardization at the following addresses:
— ISO Online browsing platform: available at https://www.iso.orgJobp
— IEC Electropedia: available at http://www.electropedia.org/
3.1 control
device actuated by an operator to execute a machine response (14)
3.2 primary control
control (3.1) that is used frequently or continuously by the operator
Note 1 to entry: The primary controls are the following:
For the base machine (3.5):
一steering;
一clutch or inch pedal;
一gear selection;
一speed (engine or ground speed);
一travel direction;
一brakes;
一swing of upper structure.
b) For equipment (3.6):
一swing operation;
raising/lowering operation (e.g. loader lift arm, dozer blade or ripper, excavator boom, side boom winch,rope excavator winch);BS ISO 10968 pdf download.