IEC 60471-2020 Clevis and tongue couplings of string insulator units – Dimensions

IEC 60471-2020 Clevis and tongue couplings of string insulator units – Dimensions. 4.1 General Two coupling systems are recommended: Couplings with limited movement; Couplings with unlimited movement. 4.2 Couplings with limited movement Couplings according to Figure 1, and Table 1, for which a limited movement of the tongue in the clevis needs to be assured. This type of coupling is used for cap and pin insulators to ensure that no contact is possible between the insulating parts of two consecutive insulators. A rectangular shape is recommended for the tongue. These couplings are designated by the nominal diameter, expressed in millimetres, of the coupling pin followed by the letter C. 4.3 Couplings with unlimited movement Couplings according to Figure 2, and Table 2, for which the movement of the tongue in the clevis is not limited. This type of coupling is used for long rod insulators. These couplings are designated by the nominal diameter, expressed in millimetres, of the coupling pin followed by the letter L. 4.4 Designation of couplings Clevis and tongue coupling are designated by the nominal diameter, expressed in millimetres,of the coupling pin which connects the clevis and tongue. A designated coupling is defined by the dimensions of the clevis, of the tongue and of the coupling pin. The Figure 1 and Figure 2 giving the diameter of the coupling pin is followed by the letter C in the case of couplings for cap and pin insulators or by the letter L in case of long rod insulators. Any confusion shall be avoided between the designation mentioned above referring to clevis and tongue couplings and the ball and socket couplings which are designated by nominal pin diameter which, in certain cases, may be followed by the letter A or B (see IEC 60120)， Therefore, the type of coupling shall always be precisely designated. 5 Dimensions All the dimensions indicated in Table 1 and Table 2 are given in millimetres, and refer to the finished articles after surface treatment such as, for instance, galvanizing (see also Figure 1 and Figure 2). NOTE The outside dimensions of the clevis have not been fixed, since they depend on the mechanical characteristics of the material used. Therefore, the length of the coupling pin is not fixed and, unless otherwise agreed, the coupling pin shall be delivered together with the clevis. A security device shall be placed to hold the pin in its...