AS NZS 5263.1.7:2020 Gas appliances Part 1.7: Domestic outdoor gas cooking appliances

AS NZS 5263.1.7:2020 Gas appliances Part 1.7: Domestic outdoor gas cooking appliances. 2.11.13 Interconnected burners Not applicable. 2.12 Components This Clause of AS/NZS 5263.0 applies 2.13 Cylinders and cylinder compartments This Clause of AS/NZS 5263.0 applies, except as modified below. 2.13.6 Protection from spillover With any removable grease receptacle removed, all cylinders, hoses and regulators shall be permanently protected from dripping cooking residues, dripping fats, spillover from vessels, and any other falling particles. 2.14 Markings This Clause of AS/NZS 5263.0 applies, except as modified below. 2.14.2 Permanent markings on appliances NOTE 1 Other marking requirements (e.g. wiring diagrams, identification of certification body and certificate number) may be applicable to a product that falls within the scope of this Standard. It is the responsibility of the Appliances shall be provided with clear and permanent markings readily accessible and easy to read and such markings shall include the following: (a) Name, trademark or identification mark of the manufacturer or responsible vendor. (b) The model designation. (c) The month and year of manufacture, or the serial number where this is documented to show month and year of manufacture. (d) The gas or gases for which the appliance is intended to be used. (e) The nominal gas consumption in MJ/h and test point pressure in kPa for each gas nominated in Item (d) above. In the case of LP Gas appliances, the input may be stated alternatively in kg/h of the specified gas. Where a side burner [or other accessory burner(s)] is intended for sale with the appliance, the marking shall state the total combined gas consumption. (f) For side burners attached to the appliance, the nominal gas consumption in MI/h and test point pressure in kPa for each gas nominated in Item (d) above. In the case of LP Gas appliances, the input may be stated alternatively in kg/h of the specified gas. (g) A warning label located on the outside of the appliance in a position where it is clearly visible to the user when operating the appliance in the installed/operating position. The warning label shall contain the elements as shown in Figure AA.101 and conform to the text and symbol heights and colours specified in Figure AA.101. (h) Any required clearances from combustible materials. (i) The correct ignition procedure for all burners, located in a position where the operator can easily read it when the appliance is in the installed position.AS...