AATCC 146-2015 Dispersibility of Disperse Dyes: Filter Test

AATCC 146-2015 Dispersibility of Disperse Dyes: Filter Test. 1.1 This test determines the dispersibility as evaluated by filtering time and fil- ter residue of disperse dyes under standard conditions in aqueous media. Additional information such as variables which affect accuracy and repeatability of the test are specified in Section 10. 1.2 This test method is to be used for determining the degree of dispersion at the specified conditions in aqueous media only. 2. Principle 2.1 A quantity of disperse dye is diluted, heated and passed through filter papers of specified micron size. The time needed for the dye dispersion to pass through the filter is then recorded. 2.2 Three tests are outlined according to intended dye application (see 10.5 and Table I). 3. Terminology 3.1 disperse dye, n.—an essentially water insoluble dye having affinity, when properly dispersed, for polyester, polya- mide and some other manufactured polymeric fibers. 3.2 dispersibility, n.—the degree to which particles can be broken down to some minimum size such that they will pass through the interstices of a standard filter paper. 4. Safety Precautions NOTE: These safety precautions are for information purposes only. The precautions are ancillary to the testing procedures and are not intended to be all inclu- sive. It is the user’s responsibility to use safe and proper techniques in handling materials in this test method. Manufacturers MUST be consulted for specific details such as material safety data sheets and other manufacturer’s recommendations. All OSHA standards and rules must also be consulted and followed. 4.1 Good laboratory practices should be followed. Wear safety glasses in all laboratory areas and a single use dust respirator while handling powder dyes. 4.2 All chemicals should be handled with care. The compounds used in this test method at the concentrations speci- fied are considered to present no signifi- cant hazard when used in accordance with good laboratory practices. 4.3 If concentrated acetic acid is diluted to prepare the 10% acetic acid, use chemical goggles or face shield, impervi- ous gloves and an impervious apron dur- ing preparation. Concentrated acids should be handled only in an adequately ventilated laboratory hood. CAUTION: Always add acid to water. 4.4 An eyewash/safety shower should be located nearby and an organic vapor respirator with full facepiece should be readily available for emergency use. 4.5 Exposure to chemicals used in this procedure must be controlled at or below levels set by governmental authorities (e.g.,...