Free Standards Online
ACI 435.8R-85 Observed Deflections of Reinforced Concrete Slab Systems, and Causes of Large Deflections. A test load of 1OO psf, corresponding to the design live load, was applied over two bays of the 24th floor. Bricks were stacked on the slab 3-l/2 months after the concrete was placed and the load was left on the slab for 6 months. The graph show- ing the measured deflection plotted against time, along with other deflection measurements, is shown in Fig. 4. It can be seen that the deflection that occurred when the test load was applied (O.13 in.) was much less than the maximum deflection that occurred during the construction period (O.33 in.) Also, at 28O days when the test load was removed, the recovery was about the same as the elastic deflection that took place at the time of application of this test load, whereas the measured recovery at the time of removal of the construction loading was only O.O1 in. The difference in these recoveries could be accounted for by the fact that the stress/strength ratio was higher at the time of application of the construction loading than when the test load was applied, and more cracking occurred during the initial appli- cation of load than during the application of test load. In both figures (6b and 6d), there is a considerable scatter around the arithmetic average of the measured deflections. The size and time dependence of the deflection are affected by several individually varying factors: for instance, different concrete ages at removal of formwork, different standards of workmanship and different loading conditions. It was observed that the deflections were considerably less for the top floor slabs. This difference was mainly due to different loading con- ditions, since the top floors did not support any floors above during the erection of the buildings. Since the span and the span-to-thickness ratio were approximately the same for the two buildings studied, a comparison might be of interest. A direct comparison of the average deflections from the two test series is made in Fig. 6 e and it can be seen that the deflection curves only deviate slightly from each other. Tests were carried out on a panel on the fourth level of a building comprising five levels of flat plate floor, four bays wide and seven bays long (Fig. 7a). The column grid was 21 ft 3 in. x 18 ft 10...

Download Address

  • Download