ISO 945-1:2019 Microstructure of cast irons – Part 1: Graphite classification by visual analysis

ISO 945-1:2019 Microstructure of cast irons – Part 1: Graphite classification by visual analysis. This document specifies a method of classifying the microstructure of graphite in cast irons by comparative visual analysis. The purpose of this document is to provide information about the method of graphite classification. It is not intended to give information on the suitability of cast-iron types and grades for any particular application. The particular material grades are specified mainly by mechanical properties and, in the case of austenitic and abrasion resistant cast irons, by their chemical composition. The interpretation of graphite form and size does not allow a statistically valid statement on the fulfilment of the requirements specified in the relevant material standard. 2 Normative references There are no normative references in this document. 3 Terms and definitions No terms and definitions are listed in this document. ISO and IEC maintain terminological databases for use in standardization at the following addresses: — ISO Online browsing platform: available at https://wwv.iso.org/bp — IEC Electropedia: available at http://www.electropedia.org/ 4 General 4.1 Designation system for classifying graphite in cast irons When cast iron materials are examined under a microscope in accordance with this document, the graphite shall be classified by the following: a) its form, designated by Roman numbers I to VI (see Figure 1 and Annex A) b) its distribution, designated by capital letters A to E (see Figure 2 and Annex B) the graphite distribution designation is only specified for grey cast irons (form I); c) its size, designated by numbers 1 to 8 (see Figures 3, 4 and .5. and Table 1). NOTE Figures 1 to ,5. show only the outlines and not the structure of the graphite. 6 Procedure for graphite classification 6.1 Procedure for visual classification of graphite The polished samples shall be scanned under a microscope in such a manner that a representative area is examined. To examine the graphite form and distribution, a x 100 magnification should preferably be chosen. If necessary, the magnification may be adapted in relation with the wall thickness so that the form and distribution of graphite can be determined by using the reference images given in Figures 1 and 2 (see also Annexes A, B. and ). Adjust the microscope magnification to match as closely as possible the corresponding images in Figures 1 and 2 before classifying the graphite form and its distribution, if appropriate. The graphite size...