ISO 19967-1:2019 Heat pump water heaters – Testing and rating for performance一 Part 1: Heat pump water heater for hot water supply

ISO 19967-1:2019 Heat pump water heaters – Testing and rating for performance一 Part 1: Heat pump water heater for hot water supply. This document specifies test conditions and test procedures for determining the performance characteristics of air source heat pump water heaters for hot water supply with electrically driven compressors with or without supplementary electric heater and connected to or including only one hot water storage tank. Hot water storage tanks that are connected in series or parallel and behave hydronically as one single tank are considered as one hot water storage tank. In the case of heat pump water heaters consisting of several parts with refrigerant or water connections, this document applies only to those designed and supplied as a complete package. NOTE This document is not applicable to testing procedures for simultaneous operation for hot water supply and space heating. “Simultaneous means that hot water supply and space heating generation occur at the same time and may interact. 2 Normative references There are no normative references in this document. 3 Terms and definitions For the purposes of this document, the following terms and definitions apply. ISO and IEC maintain terminological databases for use in standardization at the following addresses: — ISO Online browsing platform: available at https://www.iso.org/obp — IEC Electropedia: available at http://www.electropedia.org/ 3.1 heat pump water heater for hot water supply air source heat pump water heater with electrically driven compressors with or without supplementary electrical heater and connected to or including a hot water storage tank for hot water supply for human use 3.2 hot water supply water heated for human use or household or similar purposes 3.3 storage volume Vm measured volume of hot water that can be contained in the storage tank 3.4 non heated space air heat source for a heat pump which absorbs heat by an air heat exchanger in direct contact with the air inside a space in a building which is not heated.ISO 19967-1 pdf download.