BS EN 10217-4-2019 Welded steel tubes for pressure purposes – Technical delivery conditions Part 4: Electric welded non alloy steel tubes with specified low temperature properties. This document specifies the technical delivery conditions for two test categories of electric welded tubes of circular cross section, with specified low temperature properties, made from non-alloy quality steel. NOTE 1 These tube grades are intended to support the essential requirements of EU Directive 2014/68/EU in respect o1 pressure equipment with specified low temperature properties covered under all relevant Categories as set out in Article 13 of that Directive. NOTE 2 Once this standard is published in the Official Journal of the European Union (OIEU), presumption of conformity to the Essential Safety Requirements (ESR) of Directive 2014/68/EU is limited to the technical data for the materials in this standard and does not presume adequacy of the material for a specific item of pressure equipment. Consequently, the assessment of the technical data stated In this material standard against the design requirements of this specific item of equipment to verify that the ESRs of the Pressure Equipment Directive are satisfied, needs to be done by the designer or manufacturer of the pressure equipment, taking also into account the subsequent manufacturing processes which may affect properties of the base materials. 2 Normative references The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. EN 10020. Definition and classification of grades of steel EN 10021:2006, General technical delivery conditions for steel products EN 10027-1, Designation systems for steels — Part 1: Steel names EN 10027-2, Designation systems for steels — Part2: Numerical system EN 10168:2004, Steel products — Inspection documents — List of information and description EN 10204:2004, Metallic products — Types of inspection documents EN 10220, Seamless and welded steel tubes — Dimensions and masses per unit length CEN/TR 10261. Iron and steel — European standards for the determination of chemical composition EN 10266, Steel tubes, fittings and structural hollow sections — Symbols and definitions of terms for use in product standards EN ISO 148-1:2016, Metallic materials — Charpy pendulum impact test — Part 1: Test method (ISO 148- 1:2026) EN ISO 377:2017, Steel and steel products — Location and...
Download Address
Download