ISO 3185:2021 Aerospace — Bolts, normal bihexagonal head, normal shank, short or medium length MJ threads, metallic material, coated or uncoated, strength classes less than or equal to 1 100 MPa — Dimensions

ISO 3185:2021 Aerospace — Bolts, normal bihexagonal head, normal shank, short or medium length MJ threads, metallic material, coated or uncoated, strength classes less than or equal to 1 100 MPa — Dimensions. 1 Scope This document specifies the dimensions of normal bihexagonal head bolts, with close or large tolerance normal shank and short or medium length Mj threads, in metallic material, coated or uncoated, with strength classes less than or equal to 1 100 MPa. This document is applicable to the compilation of aerospace product standards. 2 Normative references The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO 286-2, Geometrical product specifications (GPS) — ISO code system for tolerances on linear sizes — Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts ISO 3353-1, Aerospace — Lead and runout threads — Part 1: Rolled external threads ISO 4095, Aerospace — Bihexagonal drives — Wrenching configuration — Metric series ISO 5855-2, Aerospace — MJ threads — Part 2: Limit dimensions for bolts and nuts ISO 7913, Aerospace — Bolts and screws, metric — Tolerances ofform and position 3 Terms and definitions No terms and definitions are listed in this document. ISO and IEC maintain terminological databases for use in standardization at the following addresses: — ISO Online browsing platform: available at https://www .org/obp — IEC Electropedia: available at http://www.electropedia.org/ 4 Configuration and dimensions See hgure 1 and Table 1. Dimensions and tolerances are expressed in millimetres. They are applicable after any coating (tolerance on shank diameter before coating is also specified for heat cured matrix coatings), but before the application of any lubricant. Details of form not stated are left to the manufacturers discretion. Tolerances of form and position shall be in accordance with ISO 7913.ISO 3185 pdf download.