IEC 63092-1-2020 Photovoltaics in buildings – Part 1: Requirements for building-integrated photovoltaic modules

IEC 63092-1-2020 Photovoltaics in buildings – Part 1: Requirements for building-integrated photovoltaic modules. This part of IEC 63092 specifies BIPV (building-integrated photovoltaic) module requirements while IEC 63092-2 specifies BIPV system requirements. Both parts specify building requirements and the applicable electrotechnical requirements (both in general and specific with respect to module assembly and application category). This document applies to photovoltaic modules used as building products. It focuses on the properties of these photovoltaic modules relevant to basic building requirements and the applicable electro-technical requirements. This document references international standards, technical reports and guidelines. For some applications, national standards (or regulations) for building products may also apply in individual countries, which are not explicitly referenced herein and for which harmonized International Standards are not yet available. The document is addressed to manufacturers, planners, system designers, installers, testing institutes and building authorities. This document does not apply to concentrating photovoltaic modules. This document addresses requirements on the BIPV modules in the specific ways they are intended to be mounted but not the mounting structure itself, which is within the scope of IEC 63092-2. 2 Normative references The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. IEC 61 082-1 , Preparation of documents used in electrotechnology – Part 1: Rules IEC 61 21 5-1 , Terrestrial photovoltaic (PV) modules – Design qualification and type approval – Part 1: Test requirements IEC 61 21 5-1 -1 , Terrestrial photovoltaic (PV) modules – Design qualification and type approval – Part 1-1: Special requirements for testing of crystalline silicon photovoltaic (PV) modules IEC 61 21 5-1 -2, Terrestrial photovoltaic (PV) modules – Design qualification and type approval – Part 1-2: Special requirements for testing of thin-film Cadmium Telluride (CdTe) based photovoltaic (PV) modules IEC 61 21 5-1 -3, Terrestrial photovoltaic (PV) modules – Design qualification and type approval – Part 1-3: Special requirements for testing of thin-film amorphous silicon based photovoltaic (PV) modules IEC 61 21 5-1 -4, Terrestrial photovoltaic (PV) modules – Design qualification and type approval – Part 1-4: Special requirements for testing of thin-film Cu(In,Ga)(S,Se)2 based photovoltaic (PV) modules.IEC 63092-1 pdf download.