UL 62841-3-13:2018 Electric Motor-Operated Hand-Held Tools, Transportable Tools And L .awn And Garden Machinery一Safety 一Part 3-13: Particular Requirements for Transportable Drills.
This clause of Part 1 is applicable, except as follows:
Addition:
This part of lEG 62841 applies to transportable drills, with manually fed axial movement of the spindle,
having a maximum chuck capacity of 13 mm.
NOTE 101 Transportable drills are also known as bench drills or drill presses.
This part of lEG 62841 does not apply to stationary drilling machines.
This part of IEC 62841 does not apply to radial arm drills.
This part of lEG 62841 does not apply to magnetic drill stands and drill motors.
NOTE 102 Magnetic drill stands and drill motors will be covered by a future part of IEC 62841-3.
NOTE 103 In Europe (EN 62841-3-13), the following conditions apply:
Radial arm drills and stationary drilling machines are covered by EN 12717.
2 Normative references
This clause of Part 1 is applicable.
3 Terms and definitions
This clause of Part 1 is applicable, except as follows:
3.2 accessory: Addition:
Note 1 to entry: Typical accessories for drills are bits for drilling and deburring.
3.101 drill: tool equipped with a typical three jaw chuck specifically designed to bore holes in various materials such as metal, plastics, wood, etc., consisting of a drill unit and a drill stand, see Figure 101.
Note 1 to entry: The drill unit or the chuck Is manually moved up and down by a means such as a hand wheel or lever.
3.102 drill unit: device consisting of a motor and the chuck
3.103 drill stand: device for supporting the drill unit in its operating position, consisting of a base plate, a workpiece support and a vertical column to which the drill unit is mounted
3.104 rest position: position of a drill unit on the column of the drill stand from where it is moved downwards onto the workpiece
Note 1 to entry: Some drill units have an adjustable rest position.
3.105 workpiece support: device for supporting the workpiece during drilling that is typically mounted to
the column and typically adjustable in height
Note 1 to entry: For some drills, the base plate is used as a workpiece support.
4 General requirements
This clause of Part 1 is applicable.
5 General conditions for the tests
This clause of Part 1 is applicable, except as follows:
5.17 Addition:
The mass of the tool shall include the drill unit including the drill chuck, even if removable, and the drill stand including the workpiece support. A fence or a workpiece vice, if any, is not included in the mass of the tool.
6 Radiation, toxicity and similar hazards
This clause of Part 1 is applicable.
7 Classification
This clause of Part 1 is applicable.
8 Marking and instructions
This clause of Part 1 is applicable, except as follows.UL 62841-3-13 pdf download.